After 7 seconds(timing is very important.1 mississippi 2 mississippi etc.) press and hold down accel pedal for approximately 10 seconds(again timing) until the hour meter starts blinking, release pedal and push down and hold again for 10 seconds) hour meter should be on with no codes showing,shut key off and test to see if codes cleared. pedal released,after 3 seconds fully depress the accel pedal 5 times within 5 seconds(end in released position). CAT Fault codes Caterpillar engines FMI diagnostic codes (FMI Fault Codes List). Replace spark plugs and make sure the GAP is correct, which is 0.38 (.096mm) if the gap is wider it could trigger that code, the code may still be present so to refresh the dash disconnecting the battery may not always reset it you would have to do the manual pedal reset which goes as follows. The complete SAE formatted fault code can be retrieved via the dash. It is an ignition related code, it is possible that something as simple as the spark plug gap being too worn out or even bad spark plugs, best best is to start with a basic tune up. E-27 is defined as a crank sensor code, Since you have replaced the crank sensor we can rule that out, if you have not already done so make sure all ignition connections are where they are supposed to be.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |